Sysprep Factory to RIS

Hi everyone,
I've just built a lovely clean image with all my different hardware drivers
and configurations included (for about 8 different hardware platforms.) It
migrates beautifully and is sitting in factory mode ready for me to reseal.

I'd like to get this "image" up onto the server for use with RIS/WDS.

Can I run riprep on an image in Factory mode and will this work ok?

This would make life very simple if it can be done. Or alternatively can I
hack the registry to take it out of factory / setup mode and then run riprep?

The goal is to ensure all the drivers stay in the install so I can use the
single image with all the drivers intact.

Also, will it upload the Text Based drivers or will I have to source them
and put them in manually?
--
"Aussie Tech"
MCP - XP, 2000 Server & 2000 Active Directory