Found New Hardware Wizard during Unattended Installation

I'm setting up a RIS image for a Dell Latitude D505. Everything's going
well, but there's one bit that's bugging me.

During GUI setup mode, at 34 minutes remaining, the Found New Hardware
Wizard appears, trying to install the monitor driver (not the display
adapter driver). The Latitude D505 simply uses the default Plug-and-Play
driver in Windows. If left alone, the wizard will remain for about three
and a half minutes before finally disappearing on its own.

Is there any way to get setup to skip this wizard automatically?

--
David
Stardate 7353.2

"David Trimboli" <trimboli@cshl.edu> wrote in
news:eeWJ3pmkHHA.3452@TK2MSFTNGP04.phx.gbl:

> I'm setting up a RIS image for a Dell Latitude D505. Everything's
> going well, but there's one bit that's bugging me.
>
> During GUI setup mode, at 34 minutes remaining, the Found New
> Hardware Wizard appears, trying to install the monitor driver (not
> the display adapter driver). The Latitude D505 simply uses the
> default Plug-and-Play driver in Windows. If left alone, the wizard
> will remain for about three and a half minutes before finally
> disappearing on its own.
>
> Is there any way to get setup to skip this wizard automatically?
>

My image does the same thing ever since I added support for the
Optiplex 745. I'm too lazy to try to fix it since it eventually
carries on.

Thanks,
Adam
--
Visit my PC Tech blog at www.leinss.com/blog