bad channel on raid controller?

I've got a megaraid elite 1600 and when I attach my array to channel 1 ---I
get multiple hard drive failures and wierd behavior such as hanging at boot.
When I attach my array to channel 2 everything works fine. Is it possible
for one channel to "go bad" while the other channel works correctly? I can
get these cards pretty cheap now like $25 and it works for my purpose but I
was just wondering if anyone had this happen and is it even possible?

Todd

"Todd Hayslett" <trhisdone@yahoo.com> writes:

>I've got a megaraid elite 1600 and when I attach my array to channel 1 ---I
>get multiple hard drive failures and wierd behavior such as hanging at boot.
>When I attach my array to channel 2 everything works fine. Is it possible
>for one channel to "go bad" while the other channel works correctly? I can
>get these cards pretty cheap now like $25 and it works for my purpose but I
>was just wondering if anyone had this happen and is it even possible?

Have you checked termination settings?


--
A host is a host from coast to coast.................wb8foz@nrk.com
& no one will talk to a host that's close........[v].(301) 56-LINUX
Unless the host (that isn't close).........................pob 1433
is busy, hung or dead....................................20915-1433