Xerox Workcentre M123 and Windows Vista

Help Help Help... I have download Vista driver for Workcentre M123 from
Xerox Support Center but when I try to print via network the Workcenter
print many fault pages... There are new setting for TCP/IP port?

Many thanks!

Max

Massimo G. <maxful@vira.it> wrote:
> Help Help Help... I have download Vista driver for Workcentre M123 from
> Xerox Support Center but when I try to print via network the Workcenter
> print many fault pages... There are new setting for TCP/IP port?

What do the fault pages say? For that matter, what does the vendor say?

--
Warren Block * Rapid City, South Dakota * USA

The Workcentre is 2 years old and I live in a small city... i don't have a
vendor!!!
Fault page is a page with a lot varius number and simbol... the printer
start to print a lot of page and I must switch off the printer for end the
job... I have try to change any option in printe menu... like processor...
Postscript value... but without solution

The printer work good with Windows XP!!!
I have sended a mail to Xerox support center and waiting an answer!

Many thank for your answer

Best regards, Max

"Warren Block" <wblock@wonkity.com> ha scritto nel messaggio
news:slrnf41hl6.3m.wblock@speedy.wonkity.com...
> Massimo G. <maxful@vira.it> wrote:
>> Help Help Help... I have download Vista driver for Workcentre M123 from
>> Xerox Support Center but when I try to print via network the Workcenter
>> print many fault pages... There are new setting for TCP/IP port?
>
> What do the fault pages say? For that matter, what does the vendor say?
>
> --
> Warren Block * Rapid City, South Dakota * USA

Massimo G. <maxful@vira.it> wrote:
> "Warren Block" <wblock@wonkity.com> ha scritto nel messaggio
> news:slrnf41hl6.3m.wblock@speedy.wonkity.com...
>> Massimo G. <maxful@vira.it> wrote:
>>> Help Help Help... I have download Vista driver for Workcentre M123 from
>>> Xerox Support Center but when I try to print via network the Workcenter
>>> print many fault pages... There are new setting for TCP/IP port?
>>
>> What do the fault pages say? For that matter, what does the vendor say?

> The Workcentre is 2 years old and I live in a small city... i don't have a
> vendor!!!
> Fault page is a page with a lot varius number and simbol... the printer
> start to print a lot of page and I must switch off the printer for end the
> job... I have try to change any option in printe menu... like processor...
> Postscript value... but without solution

[please don't top-post, it makes responding difficult]

Pages with garbled symbols can happen from the printer being interrupted
during a job, or possibly by receiving a job with commands that it
doesn't understand. For example, if the printer only supports PCL 3 but
the new driver sends PCL 5, or the same with PostScript level 2 versus
level 3.

It's unlikely, but worth checking to see if Xerox has a firmware update
for the printer. The Vista driver may require newer firmware.

There may be some networking "feature" of Vista that is interfering with
network communications, like a firewall.

> The printer work good with Windows XP!!!

A lot of people are experiencing problems with Vista. Many go back to
XP.

> I have sended a mail to Xerox support center and waiting an answer!

When or if you receive a response, please post it in this thread.

--
Warren Block * Rapid City, South Dakota * USA