To bad your relabeler will not tell you what you are buying or properly
disclose and label what it is on their website. But do not despair
since all of the relabelers are the same.
Dave C. wrote:
> I have a HP Photosmart 7660 which uses 56 and 57 cartridges. I am looking
> to buy an HP6940 printer which uses 96 and 97 cartridges.
>
> I have been filling the 56 and 57 carts successfully. The spec on the 6940
> refers to Vivera ink.
>
> Is this the same ink that I have been using for the 56 and 57 carts?
>
> My supplier web site shows the same black and same tri-colors for these
> carts. I have not yet check with my supplier on this yet.
>
> Any thoughts on this would be appreciated.
>
> Dave C.
>
>
>
On Fri, 1 Jun 2007 15:58:03 -0400, "Dave C." <myaddress@microsoft.com>
wrote:
>I have a HP Photosmart 7660 which uses 56 and 57 cartridges. I am looking
>to buy an HP6940 printer which uses 96 and 97 cartridges.
>
>I have been filling the 56 and 57 carts successfully. The spec on the 6940
>refers to Vivera ink.
>
>Is this the same ink that I have been using for the 56 and 57 carts?
>
>My supplier web site shows the same black and same tri-colors for these
>carts. I have not yet check with my supplier on this yet.
>
>Any thoughts on this would be appreciated.
>
>Dave C.
>
I have a similar situation. One printer uses 56, 57, other uses
94,95/97.
The coloured ink is diferent between 57 - 95/97
Black ink has different refill kits from some suppliers, but the same
ink can be used by both black carts.
The only problem you will have is the chip in 96/97 carts.
You cannot reset the ink level by rotating 3 carts.
If you refill the carts you have to alter the printer to ignore the
ink level.
I had problems with both carts. The ink actually ran out before the
ink level showed empty. This caused premature failure of the carts.
I usually start refilling when level shows half full but left it too
long on 94/95 carts.
The ink used is the same for 92,94,96 and 93,95,97. Just different
cart capacity
"Dave C." <myaddress@microsoft.com> wrote in message
news:nY-dnf4UoaT85_3bnZ2dnUVZ_hCdnZ2d@comcast.com...
>I have a HP Photosmart 7660 which uses 56 and 57 cartridges. I am looking
>to buy an HP6940 printer which uses 96 and 97 cartridges.
>
> I have been filling the 56 and 57 carts successfully. The spec on the
> 6940 refers to Vivera ink.
>
> Is this the same ink that I have been using for the 56 and 57 carts?
The ink that HP puts in the 56/57 is very different than that in the 96/97
cartrdiges.
> My supplier web site shows the same black and same tri-colors for these
> carts. I have not yet check with my supplier on this yet.
>
> Any thoughts on this would be appreciated.
You get what you pay for.... the color maps are different between the 57
and 97 inks, if you use the same ink for both at least one of them will be
"wrong".
I have a HP Photosmart 7660 which uses 56 and 57 cartridges. I am looking to buy an HP6940 printer which uses 96 and 97 cartridges. I have been filling the 56 and 57 carts successfully. The spec on the 6940 refers to Vivera ink. Is this the same ink that I have been using for the 56 and 57 carts? My supplier web site shows the same black and same tri-colors for these carts. I have not yet check with my supplier on this yet. Any thoughts on this would be appreciated. Dave C.
I have a similar situation. One printer uses 56, 57, other uses 94,95/97. The coloured ink is diferent between 57 - 95/97 Black ink has different refill kits from some suppliers, but the same ink can be used by both black carts. The only problem you will have is the chip in 96/97 carts. You cannot reset the ink level by rotating 3 carts. If you refill the carts you have to alter the printer to ignore the ink level. I had problems with both carts.
If you use genuine HP ink you would not have had these problems.
The ink actually ran out before the ink level showed empty. This caused premature failure of the carts. I usually start refilling when level shows half full but left it too long on 94/95 carts. The ink used is the same for 92,94,96 and 93,95,97. Just different cart capacity I hope this helps DJT
"DJT" <dtope@hotmail.com.au> wrote in message
news:gmo1631ret2mtfibmppu2pi24glv4fltss@4ax.com...
> On Fri, 1 Jun 2007 15:58:03 -0400, "> I have a similar situation. One
> printer uses 56, 57, other uses
> 94,95/97.
> The coloured ink is diferent between 57 - 95/97
> Black ink has different refill kits from some suppliers, but the same
> ink can be used by both black carts.
>
> The only problem you will have is the chip in 96/97 carts.
>
> You cannot reset the ink level by rotating 3 carts.
> If you refill the carts you have to alter the printer to ignore the
> ink level.
> I had problems with both carts. The ink actually ran out before the
> ink level showed empty. This caused premature failure of the carts.
> I usually start refilling when level shows half full but left it too
> long on 94/95 carts.
>
> The ink used is the same for 92,94,96 and 93,95,97. Just different
> cart capacity
>
> I hope this helps
>
> DJT
Yes, very helpful. The reason for the interest in theHP6940 is that in this
model (as well as some others) have the print head in the cartridge as
opposed to other HP's with the heads permanent in the printer. I feel more
comfortable with the head in the cartridges.
Hope HP does not eliminate the cartridge-in-the-head models. I guess the
ones permanently in the printer might want to compete with Epson or others.
Cartridge filling ink 
Linear Mode
