AIW 9700 Pro

I have an AIW 9700 Pro. Can I get this to display
satellite TV, by running coax from the satellite
receiver out to the CATV input on this card? (The
satellite receiver can output on Channel 3 or 4).

So far, when I do that, I get a message "no
signal" on the TV display, and the channel scan
gives no results. Is there a way I can tune the
card to receive channel 3 or 4 per above?

"gus" <gus_zernial@yahoo.com> wrote in message
news:1177464803.773557.57980@b40g2000prd.googlegro ups.com...
>I have an AIW 9700 Pro. Can I get this to display
> satellite TV, by running coax from the satellite
> receiver out to the CATV input on this card? (The
> satellite receiver can output on Channel 3 or 4).
>
> So far, when I do that, I get a message "no
> signal" on the TV display, and the channel scan
> gives no results. Is there a way I can tune the
> card to receive channel 3 or 4 per above?
>

You have to set the antenna input to antenna (not Cable) on the Settings >
TV Tuner page to receive channel 3/4.
The cable length should be less than 20 feet to avoid signal loss.
Satellite receiver must be on and tuned to a active channel before the tuner
setup will see it.