|
|
|
|
| Author |
Message |
Mickey Mouse
Guest
|
 Posted: Tue Dec 28, 2004 10:02 am Post subject: Master / Slave |
 |
|
Hi, just installed a new (second) burner onto my system. If you have two
burners on a system do they need to be configured as master and slave or
doesn't it matter?
Mickey |
|
| Back to top |
|
 |
|
|
Panos Popadopalous
Guest
|
| Posted: Tue Feb 15, 2005 12:15 am Post subject: Re: Master / Slave |
|
|
If they share the same flat ribbon, then you must set the one at end as
Master, and the one in the middle as Slave.
"Mickey Mouse" <mickey_mouse@lizzy.com.au> wrote in message
news:1104224553.499647@kangaroo.ozonline.com.au...
| Quote: | Hi, just installed a new (second) burner onto my system. If you have two
burners on a system do they need to be configured as master and slave or
doesn't it matter?
Mickey
|
|
|
| Back to top |
|
|
Globe-trotter
Guest
|
| Posted: Fri Feb 25, 2005 4:27 pm Post subject: Re: Master / Slave |
|
|
On Mon, 14 Feb 2005 18:28:25 -0500, "Panos Popadopalous"
<panos@athens.net> wrote:
| Quote: | If they share the same flat ribbon, then you must set the one at end as
Master, and the one in the middle as Slave.
|
BULLSHIT !!! It matters NOT where the Master & Slave are attached on
the cable !!! What DOES matter are the settings of the JUMPERS on the
two units !! (Close - but no Cigar!)
| Quote: |
"Mickey Mouse" <mickey_mouse@lizzy.com.au> wrote in message
news:1104224553.499647@kangaroo.ozonline.com.au...
Hi, just installed a new (second) burner onto my system. If you have two
burners on a system do they need to be configured as master and slave or
doesn't it matter
|
Of course IT MATTERS !! You can't have BOTH as Slave or Master !
|
|
| Back to top |
|
|
|
|
| |
Watched Topics
Search
Register
Log in to check your private messages
Profile
Log in
Memberlist
Usergroups