HowToFixComputers.com

Boon · Guest

Does anyone know if you can run an 80 gig drive off a 503+ motherboard?
I'm running the JE4333 BIOS, which has "added support for HDD up to 65
Gig" according to the BIOS document.

The 80 gig drive runs Win 2000 and is now hooked to a Promise Ultra 100 TX2
controller. It's had problems with Windows updates for a couple years.
I've just let it go because I haven't been using the computer seriously.
But now I'm thinking about using it to support a USB disk farm, so I'd like
to solve the problem. I suspect the update problem has to do with the
operating system running off the controller. I see two options:

1) Attach the 80 gig drive to the motherboard, but this might give new
problems.
2) Replace the 80 gig drive with a 40, reinstall Win 2000, and attach that
directly to the motherboard. This, of course, is a hassle.

Thanks in advance for any thoughts.

Gerald Abrahamson · Guest

On 28 May 2007 21:51:52 GMT, Boon <nobody@nownere.net> wrote:

no-spam · Guest

Gerald Abrahamson wrote:

Boon · Guest

Thanks to Jerry and billh for replies. It's good news to me that I can use
my 80 gig drive off the motherboard. I moved it, and got the BIOS to auto-
recognize the drive by setting Type = Auto and Mode = LBA. The bad news is
that Windows update still tells me that "Updates were unable to be
successfully installed." I messed around a bit, but I just can't get the
update to work. I was wrong in blaming the Promise controller.

The Win 2000 I'm running is 5 years old. By now it probably needs that
"good housecleaning" that billh recommends, so I think I'll just go ahead
and reinstall Win 2000.

Couple tech details:
I'm using 2.20.0.15 Promise BIOS
2.0.0.29 driver version, 2.00.0.42 file version
My TX2 is in the third and last PCI slot counting away from the video slot.
Does it make a difference?

Thanks again, guys, for your info. You've given me the benefit of using my
80 gig drive instead of a 40.

- Dave

Kyle · Guest

Set your internet security settings back to default levels and then
try Windows Update. Also, there are some services that cannot be
disabled (Automatic Updates and BITS for example, Background
Intelligent Transfer Service) as Windows Update relies upon them to
work properly.

--
Best regards,
Kyle
"Boon" <nobody@nownere.net> wrote in message
news:Xns994067A3D13A6ddboonastrawebnet@216.151.153.46...
| Thanks to Jerry and billh for replies. It's good news to me that I
can use
| my 80 gig drive off the motherboard. I moved it, and got the BIOS
to auto-
| recognize the drive by setting Type = Auto and Mode = LBA. The bad
news is
| that Windows update still tells me that "Updates were unable to be
| successfully installed." I messed around a bit, but I just can't
get the
| update to work. I was wrong in blaming the Promise controller.
|
| The Win 2000 I'm running is 5 years old. By now it probably needs
that
| "good housecleaning" that billh recommends, so I think I'll just go
ahead
| and reinstall Win 2000.
|
| Couple tech details:
| I'm using 2.20.0.15 Promise BIOS
| 2.0.0.29 driver version, 2.00.0.42 file version
| My TX2 is in the third and last PCI slot counting away from the
video slot.
| Does it make a difference?
|
| Thanks again, guys, for your info. You've given me the benefit of
using my
| 80 gig drive instead of a 40.
|
| - Dave

no-spam · Guest

Boon wrote:

Boon · Guest

Thought you guys might like hear of my further VA 503+ adventures. I
first tried installing Win 2000 on 5 gigs of a new 320 gig drive attached
to the TX2. I hit F6 so I could feed in the TX2 driver. This
installation hung up on the "Installing Devices" screen. Next I tried
the installation on an 80, then a 40 gig drive, with variations on
attachments to the TX2 or to the motherboard. After many hours I
concluded that both drives were bad. The 80 had bad blocks, which
probably caused the original windows update problem. I think the 40 has
a bad boot sector, I hope just bad data that I can fix, but for this job
I gave up on it. I then tried a 4 gig WD Caviar. By this time I was fed
up with screwing and unscrewing drives into the case, so I just ran the
Caviar from on top. This time the installation was a breeze. And after
a couple hours this sweet little drive felt just barely warm.

Windows Update worked fine. I installed a few simple apps to help with
my disk farm. Then I installed the free McAfee that I get with Comcast.
Thereafter the system re-booted sporadically and without notice. I did
some diagnostics and concluded that McAfee was the problem. I replaced
it with Zone Alarm 3.7. No more surprise boots. I have another similar
503+ that runs the McAfee with no problem. Go figure.

Anyhow, this 503+ is back in business. The OS is on the Caviar, a 320
gig drive is on the TX2, and I plan to hang 7 more big drives off the
USB. This has taken me two full days. As usual I am sometimes amazed at
my brilliant insight into the situation, and at other times amazed at my
abject stupidity. I'm glad I don't do this for a living. Or, for that
matter, anything - I'm retired.

Alex Zorrilla · Guest

Not bad, Boon. Not bad at all. :-)

But 7 big hard drives off the USB? On a USB 1.1 motherboard? Save
yourself some sanity. Shell out the $10 for a USB 2.0 PCI card, if you
do not already have one. This should make a huge difference in
performance for those drives.

Boon wrote:

Boon · Guest

Alex,

You’re right, USB 1.1 is terribly slow. I think I still have that little
2-port 1.1 USB riser that came with the 503+, but I never used it. I’m
using a Belkin USB 4-port PCI card and a 4-port hub to give me 7
connections to support about 2 terabytes of disk storage. The USB card,
the TX2, and a 10/100 ethernet card use up all the PCI slots. Also, I’m
using an ancient ISA Sound Blaster card that works quite well.

- Boon

Alex Zorrilla · Guest

Hey, Boon.

It's amazing how these things can keep running forever if you want them
to, isn't it?

Cheers.

--Alex

Boon wrote: