HowToFixComputers.com




Watched TopicsWatched Topics SearchSearch RegisterRegister Log in to check your private messagesLog in to check your private messages ProfileProfile Log inLog in
SJ1 Jumper at ECS KV2 mainboard (power led)

 
Post new topic   Reply to topic    Index -> Elitegroup
Author Message
M.A.Rauder
Guest
PostPosted: Wed May 16, 2007 3:36 pm    Post subject: SJ1 Jumper at ECS KV2 mainboard (power led) Reply with quote
@my question about the front panel pin connector
power led and the Jumper SJ1 on the ECS KV2:

"ECS Support Posted : GMT 2007/05/14 09:26:55

Dear Customer,

SJ1 pin is made for old ATX cases which use three pins connector power LED.

You can use one of those two connectors as well as both gives 5V signal.

Thanks & regards,
Elitegroup Computer Systems EU B.V.
Technical Support Department"
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Index -> Elitegroup All times are GMT
Page 1 of 1

 

 MemberlistMemberlist  UsergroupsUsergroups


Powered by p|-|pBB

Featured Sites: DIY Projects