|
|
|
|
| Author |
Message |
gus
Guest
|
 Posted: Wed Apr 25, 2007 6:33 am Post subject: AIW 9700 Pro |
 |
|
I have an AIW 9700 Pro. Can I get this to display
satellite TV, by running coax from the satellite
receiver out to the CATV input on this card? (The
satellite receiver can output on Channel 3 or 4).
So far, when I do that, I get a message "no
signal" on the TV display, and the channel scan
gives no results. Is there a way I can tune the
card to receive channel 3 or 4 per above? |
|
| Back to top |
|
 |
|
|
PhxGrunge
Guest
|
| Posted: Wed Apr 25, 2007 3:13 pm Post subject: Re: AIW 9700 Pro |
|
|
"gus" <gus_zernial@yahoo.com> wrote in message
news:1177464803.773557.57980@b40g2000prd.googlegroups.com...
| Quote: | I have an AIW 9700 Pro. Can I get this to display
satellite TV, by running coax from the satellite
receiver out to the CATV input on this card? (The
satellite receiver can output on Channel 3 or 4).
So far, when I do that, I get a message "no
signal" on the TV display, and the channel scan
gives no results. Is there a way I can tune the
card to receive channel 3 or 4 per above?
|
You have to set the antenna input to antenna (not Cable) on the Settings >
TV Tuner page to receive channel 3/4.
The cable length should be less than 20 feet to avoid signal loss.
Satellite receiver must be on and tuned to a active channel before the tuner
setup will see it. |
|
| Back to top |
|
|
|
|
| |
Watched Topics
Search
Register
Log in to check your private messages
Profile
Log in
Memberlist
Usergroups