|
|
|
|
| Author |
Message |
Guest
|
 Posted: Wed Feb 21, 2007 8:22 am Post subject: P965 Platinum fails during XP install |
 |
|
I am attempting to set up a new machine with the P965 Platinum MB.
While installing Windows that system crashes as soon as the all the
drivers are loaded and it says "Starting Windows" or words to that
affect, meaning it is now going into graphics mode. I then get a blue
screen with a long "STOP" address and a reference to pci.sys and
another address.
I am only using an IDE CD-RW and IDE HD. No SATA. I've installed a
floppy drive so I could flash the BIOS. It is now current at version
1.3. I have also tried to install the JMicron drivers (F6 during
Windows setup), but the results were the same.
Anyone have any ideas? |
|
| Back to top |
|
 |
|
|
Guest
|
| Posted: Mon Feb 26, 2007 1:47 am Post subject: Re: P965 Platinum fails during XP install |
|
|
Get the stop code, the first hex number on the blue screen. It gives
a specific reason for the failure. Look it up in the MS Knowledge
Base "Stop Code xxxxx" or Google the same to check for the reason and
suggested fixes. Good luck.
On Feb 20, 9:22 pm, dannv...@gmail.com wrote:
| Quote: | While installing Windows that system crashes as soon as the all the
drivers are loaded and it says "Starting Windows" or words to that
affect, meaning it is now going into graphics mode. I then get a blue
screen with a long "STOP" address and a reference to pci.sys and
another address. |
|
|
| Back to top |
|
|
torr
Guest
|
| Posted: Sat Apr 07, 2007 7:52 am Post subject: Re: P965 Platinum fails during XP install |
|
|
I had the same problem .
Sounds like your installing winxp with service pack 1 or less.
I think this board requires xp with service pack 2 to install , it solved my
problem
regards
torr
<dannveld@gmail.com> wrote in message
news:1172024545.168965.23930@t69g2000cwt.googlegroups.com...
| Quote: | I am attempting to set up a new machine with the P965 Platinum MB.
While installing Windows that system crashes as soon as the all the
drivers are loaded and it says "Starting Windows" or words to that
affect, meaning it is now going into graphics mode. I then get a blue
screen with a long "STOP" address and a reference to pci.sys and
another address.
I am only using an IDE CD-RW and IDE HD. No SATA. I've installed a
floppy drive so I could flash the BIOS. It is now current at version
1.3. I have also tried to install the JMicron drivers (F6 during
Windows setup), but the results were the same.
Anyone have any ideas?
|
|
|
| Back to top |
|
|
|
|
| |
Watched Topics
Search
Register
Log in to check your private messages
Profile
Log in
Memberlist
Usergroups