HowToFixComputers.com




Watched TopicsWatched Topics SearchSearch RegisterRegister Log in to check your private messagesLog in to check your private messages ProfileProfile Log inLog in
KN9 Ultra SATA Info Required

 
Post new topic   Reply to topic    Index -> ABIT
Author Message
Chris
Guest
PostPosted: Mon Feb 19, 2007 2:36 am    Post subject: KN9 Ultra SATA Info Required Reply with quote
Installed XP2 onto new seagate 320GB sata 300 HDD, did not install raid
drivers when prompted but XP went ahead and started with no problems.
The question is this, with 6 SATA ports on board I do not need to
configure a raid array. It appears that in the device manager it sees
the drive as an IDE drive, therefore will the drive operate at Sata 300
rate or default to ATA rate.
Hope this makes sense, I`m new to this


--
Chris
------------------------------------------------------------------------
Chris's Profile: http://www.futurehardware.in/member.php?userid=881
View this thread: http://www.futurehardware.in/showthread.php?t=572764

Future Hardware - http://www.futurehardware.in
Back to top
Fix your Windows Problems - FAST.
FREE Safe Scan Registry Check. Locate & Fix Errors in Minutes!
Display posts from previous:   
Post new topic   Reply to topic    Index -> ABIT All times are GMT
Page 1 of 1

 

 MemberlistMemberlist  UsergroupsUsergroups


Powered by p|-|pBB

Featured Sites: DIY Projects