chip
Guest
|
 Posted: Thu Jan 25, 2007 6:02 pm Post subject: BE6-IIv2 -- Adding 80GB WD only mirrors existing drive |
 |
|
ABIT BE6-II v1.2
Win98 Ver 4.10.1998 (No SE)
Intel Pentium III 550E
Intel Corporation 82443BX/ZX 440BX/ZX
Super I/O: Winbond 83977EF-AM
Clock Chip: RTM520-39D
Original BIOS ID: 05/22/2000-I440BX-W977-6A69KA1BC-RW
BIOS Upgrade from eSupport:
12/03/2001=I440BX-W977-6A69KA1BC-71
HPT370 Driver - 0.95b
SDRAM (2-256 PC133) + (1-128 PC125)
3D RAGE PRO AGP 2X (ATI)
Creative -SB PCI128
Writer - PLEXTOR CD-R PX-W8432T
Writer - Generic IDE-CD R/RW
======
Hi all,
The ABIT box is still solid and last I checked the caps were ok too.
It is configured with 2 HDDs and 2 Opticals on the main channels and 3
HDDs on the HPT.
Swapped out the 20GB slave on the system drive with an 80GB. After I
rebooted, the newly installed 80GB (D was now showing the contents
of an 80GB (G on IDE4 of the HPT controller. You could look through
directories and open files just as if you were actually looking at
(G Both are WD800JB's and (G is pinned as a single drive.
I switched the original drive back in without changing anything else,
rebooted, and things were back to normal.
Can someone tell me why this drive is not being seen separately?
--
After enlightenment,
the laundry. |
|
Watched Topics
Search
Register
Log in to check your private messages
Profile
Log in
Memberlist
Usergroups